Matrix BMS 1400-3 Traduction De La Notice Originale page 29

- Move the choke lever (B25) down:
- Pull the starter cable through quickly and
forcefully until the cable end several times, until
the engine starts.
CAUTION - DANGER: The engine starts
at half acceleration and with the
rotating cutting tool. Keep the engine running
for a few seconds.
When the throttle control is pressed shortly, the
Locking button switches off automatically. The
engine returns to idle running. The cutting tool
stops after several seconds.
Turning off the Engine
- Let the engine return to idle running without
pressing the throttle control.
- Move the operating switch (4) at the operating
handle to "STOP" position (B26).
CAUTION. The cutting tool continues
rotating for a few seconds after the
engine is turned off. Hold both handles
until the cutting tool has come to complete
stop.
Starting when the Engine is Warm
- This is similar to the start of a cold engine. In this
case, the choke level is always kept at
at the bottom (B25).
Working with petrol brush cutter
- When you work with the petrol brush cutter
for the first time, familiarize yourself with the
operation and control of the petrol cutting blade
without running engine.
- The design of the petrol brush cutter
allows for operation only at the right side
of the user's body.
- Always use both hands to hold the handles of
the petrol cutting blade.
- Use your right hand to hold the operating
handle, and your left hand to hold the handle of
the handle tube.
- Always keep in mind that the cutting tool keeps
rotating for a short while after the throttle control
was released.
- Always ensure a proper idle running of the
engine so that the cutting tool will no longer
rotate, when the throttle control is pressed.
- Always use the highest speed for work, this way
you will achieve the best cutting result.
If you hit a stone or tree during work, switch off
the engine and inspect the petrol brush cutter for
damages.
Caution: When working in a difficult surrounding
and on slopes, always stand below the cutting
head.
Always wear safety goggles and ear protection,
and a safety helmet during work in a forest.
Using Trimmer head for Cutting
- Use the plastic line cassette for a clean cut also
at uneven edges, fencing posts, and trees.
- Carefully advance the trimming line to an
position
obstacle, and use the tip of the line to cut around
the obstacle. When the trimming line comes into
contact with stones, trees, and walls, the line
wears out or breaks off ahead of time.
- Swing the petrol cutting blade like a normal
scythe horizontally from right to left and
back again. You define the cutting height
depending on how high you are holding the tool.
- Never replace the nylon line with a metal wire.
RISK OF INJURIES
29