Matrix BMS 1400-3 Traduction De La Notice Originale page 30

Using Cutting Blade for Cutting
- Use the cutting blade to comb through
brushwood, rank growth, young tree populations
(trunk diameter of maximum 2 cm), and high
grass.
- While using metal cutting tools, there is
generally a risk of recoil, when the tool hits a solid
obstacle (stones, trees, branches, etc.). Thereby,
the tool is hurled backwards against the rotating
direction.
- To cut rank growth and brushwood, you
"immerse" the cutting blade from the top. This
way, the objects to be cut will be chaed.
CAUTION: Be especially careful, when using this
working technique, because the further away the
cutting tool is from the ground, the higher is the
risk that objects to be cut and particles will be
hurled sideways.
- To comb through young tree populations and to
cut grass, move the tool like a scythe closely
above the ground.
CAUTION: Incorrect use and misuse can damage
the bush cutter and cause severe injuries because
of pieces hurled away.
- To minimize the risk of accidents by use of the
cutting blade, take note of following points:
- Never cut shrubbery or wood whose diameter is
larger than 2 cm.
- Avoid contact with metal bodies, stones, etc.
- Periodically check the cutting blade for
damages.
Never continue to use a damaged cutting blade.
- When the cutting blade becomes apparently
blunt, it must be sharpened according to
instructions.
30
When the cutting blade is apparently out of
balance, it must be replaced.
Automatic Feeding of Trimming Line
The petrol cutting blade is delivered with a lled
line cassette.
This line will wear out during work. To feed new
line, forcefully press the head of the line cassette
onto the ground while the engine is running.
The line is automatically fed due to centrifugal
force.
The knife at the line guard will shorten the
trimming line to the correct length.
Renewal of Trimming Line
To avoid the risk of an unwanted engine start, pull
out the spark plug socket. RISK OF INJURIES
- Pull off the line guard cap from the line spool by
forcefully pressing between the retaining
plates (B27).
- Remove the spool with line remaining and the
compression spring (B28).
- Remove the used up spool (B29).
- Take the new line spool and pull out 10 cm at
both lines each.
- Now, place the line spool on the tapered spring,
and guide both lines each through the round
metal lugs at the line spool housing (B30).
- Then place the spool cover on the new line
spool (B31). Turn it so that the plates of the spool
cover are push with the springs in the line spool
housing.
- Now, press the spool cover together with the
line spool, until it engages in the line spool
housing.