34 9.7 Machinery Noise Information - Bosch EPS 807 Notice Originale

9.7 Machinery noise information
Machinery noise information pursuant to the equipment
safety code
Noise measurement pursuant to DIN 45 635, Part 1, to
determine:
1. Acoustic power levels L
2. Workplace-related emission value L
i
The noise emission of an operating injection pump
test bench is dependent to a great extent on the
injection pump which is to be tested. As there is still
no specification for a "standard" injection pump,
we state values for the injection pump test bench
without an injection pump and two values with typi-
cal injection pumps.These are not maximum values.
Higher noise levels may occur with larger or more
powerful injection pumps.
i
The following values were measured on an EPS 815:
MGT measuring system
Test speed
1. Acoustic power level A L
WA
Values in dB
2. Workplace-related emission value L
(re 20 µ Pa) Values in dB
KMA measuring system
Test speed
1. Acoustic power level A L
WA
Values in dB
2. Workplace-related emission value L
µ Pa) Values in dB
Robert Bosch GmbH
WA
pA
Test bench
without injection pump
n = 0
(re 1 pW) 79,6
68
pA
Test bench
without injection pump
n = 0
(re 1 pW) 79,6
(re 20 68
pA
Technical Data | EPS 807 / 815 | 47
Test bench
with VE injection pump
n = 4000 n = 1750
87,8 92,1
84,5 84,3
Test bench
with VE injection pump
n = 4000 n = 1750
87,8 94
84,5 86,3
Test bench
with PE injection pump
n = 2675 n = 500 n = 1050
93,6 94,4 102,8
88,7 86,4 96,5
Test bench
with PE injection pump
n = 2675 n = 500 n = 1050
94,1 93,9 104,5
88,6 85 96,3
|
1 689 979 672
en
2012-06-26