EMAK PPX 271 Manuel D'utilisation Et D'entretien page 27

the tank or a container for a long time. Were
commend the use of the additive Emak ADDITIX
2000 code 001000972 if the mixture is to be
stored for 12 months.
Alkylate gasoline
CAUTIONS – Alkylate fuels have different
density than normal fuel. Therefore engines,
set with normal fuel, need different H jet
regulation to avoid critical issues. For this
operation it's necessary turned at a Licensed
Service Dealer.
Filling the tank
stir the mixture well before refuelling.
CHAIN LUBRICATING OIL
CAUTION – The tool is supplied without
chain lubricant.
Correct chain lubrication during the cutting
phase reduces wear to a minimum between the
chain and bar thus prolonging life. Always use a
good quality oil.
WARNING - Never use waste oil. Always
use biodegradable lubrificant (eco-lube
O l e o - M a c p . n . 0 0 1 0 0 1 5 4 8 ( 5 ℓ ) -
001001549 (1ℓ) - eco-lube Efco p.n. 001001552
(5ℓ) - 001001553 (1ℓ)) which is specific for bar
and chain and also respectful towards nature
and machine's parts.
Before starting make sure the chain is not
obstructed.
When the engine is idling the chain must
not turn. Otherwise contact an Authorized
Service Center to carry out a check and fix the
problem.
When the motor is running, grip the front
handle firmly with your left hand and the back
handle with your right hand. Check that all
parts of the body are kept away from the chain
and muffler. Never use a cross-handed grip.
Left-handers should follow these instructions
too. Keep a proper cutting stance.
Over exposure to vibrations can result in
blood-vessel or nerve injury to persons
suffering with blood circulation problems. Seek
medical attention if you experience physical
symptoms such numbness, lack of feeling,
reduction in normal strength, changes in the
colour of the skin. These symptoms normally
appear in the fingers, hands or wrists.
WARNING: Follow safety instruction for
fuel handling. Always shut off engine before
fuelling. Never add fuel to a machine with a
running or hot engine. Move at least 3 m from
refuelling site before starting engine. DO NOT
SMOKE!
1. Clean surface around fuel cap to prevent
contamination.
2. Loosen fuel cap slowly.
3. Carefully pour fuel mixture into the tank.
Avoid spillage.
4. Prior to replacing the fuel cap, clean and
inspect the gasket.
5. Immediately replace fuel cap and hand
tighten. Wipe up any fuel spillage.
WARNING: Check for fuel leaks, if any are
found, correct before use. Contact a Servicing
Dealer if necessary.
Engine is Flooded
- Engage a suitable tool in the spark plug boot.
- Pry off the spark plug boot.
- Unscrew and dry off the spark plug.
- Open the throttle wide.
- Pull the starter rope several times to clear the
combustion chamber.
- Refit the spark plug and connect the spark
plug boot, press it down firmly.
- Set the choke lever to OPEN position – even if
engine is cold.
- Now start the engine.
GB
23