Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Morsø 5660 Outside Air Kit
The kit consists of:
1 pcs. Outside Air Box
1 pcs. cover plate
2 pcs. screws 6x35 mm
2 pcs. screws 6x55 mm
110 cm tape
1. Before fitting the air kit set knock out the steel plate (1) in the insert box. This is best
done by applying gentle hammer taps immediately onto the small "bridges" in the circu-
lar cutouts.
2. Remove cast combustion chamber from the convection box and unscrew the control bar (4)
from the cast iron base fastened with the screw (5) in the middle. Now place the cover plate
(3) around the air slide fitted (6) at the back of the stove (see drawing). Refit the control bar
(4) on the cast iron base plate.
3. The 4 M6x8 screws fitted at the back of the cast iron plate, where the air kit box is to be
fastened, are removed.
4. Paste the tape (7) to the edge all around the air kit box.
5. Remove the 4 M6x8 (2) screws located at the back of the cast iron plate where the air
kit box is to be fitted. Make sure that the cover plate (3) is fitted correctly inside at the
bottom of the box. (see drawing).
The stove can be installed. See the enclosed Instructions for installation and use.
1
Ø127
2
2
2
Ø108
7
2
6
3
4
5
b
Påført glastape
Rev.
Revisions
Publicité
