Touch Sft Multifunction Control Panel; Function; Sailing Or Mooring Mode - Thetford Marine TECMA Compact Line Manuel D'installation Et D'utilisation

4.4

Touch SFT Multifunction control panel

Function

The Touch SFTMultifunction control panel can work both in Navigation mode and in
Mooring mode.
The Navigation mode cycle eliminates the water inside the bowl at the end of use, preventing
the possible leakage of water due to the movements of the boat.
The mooring mode cycle works like domestic toilets: just the activation of the "AFTER USE"
button is enough to activate the cycle in its entirety. In Mooring mode there is always a
quantity of water inside the bowl to create a hydraulic cap.
BEFORE USE
LOCK OUT
To switch from mooring mode to navigation mode see
NOTE: If desired, the amount of water that is used during each drain cycle can be
adjusted directly on the back of the Touch panel. In fact, in the rear part of the latter
there is a special regulator that can be operated by turning it clockwise to increase
the amount of water or counterclockwise to decrease it. The recommended water
level is 1 cm above the exhaust outlet.

Sailing or Mooring mode

Set the system to sailing mode if you plan on sailing often. The toilet will remain empty after use.
Only a small amount of water will be added to create a water trap. This will avoid accidental water
spilling caused by motion of the vessel during navigation.
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Compact line | Installation and use manual | ENG
par. 2.3.3.
49
AFTER USE
TANK LEVEL
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com