Zanussi ZDC8203W Notice D'utilisation page 14

The appliance stops during operation.
The cycle time is too long or unsatisfactory dry-
1)
ing result.
The display shows Err.
The display shows (e.g. E51).
1) After maximum 5 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the appliance.
• The drum is dirty.
• Incorrect setting of the conductivity sensor
( See chapter "Settings - Adjustment of the
TECHNICAL DATA
Height x Width x Depth
Max. depth with the appliance door open
Max. width with the appliance door open
Adjustable height
Drum volume
14
Problem Possible solution
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
Make sure that the water container is empty.
Press Départ/Pause (Start/Pause) to start the
programme again.
Make sure that the weight of the laundry is appli-
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Ensure that the room temperature is higher than
+5°C and lower than +35°C. Optimal room tem-
perature is 19°C to 24°C.
Set the Minuterie (Time Drying) or the Très Sec
(Extra Dry) programme.
If you want to set a new programme, deactivate
and activate the appliance.
Make sure that the options are applicable to the
programme.
Deactivate and activate the appliance. Start a
new programme. If the problem occurs again,
contact the Service.
remaining laundry moisture degree " for better
setting).
• The airflow slots are clogged.
• Room temperature is too low or too high
( optimal room temperature 19°C to 24°C )
850 x 600 x 600 mm (maximal 665 mm)
1090 mm
950 mm
850 mm (+ 15 mm - feet regulation)
118 l
2)