Operation - Wolf Garten Campus 30 V Mode D'emploi

If the connection cable is damaged during use it must be dis-
connected immediately. Do not touch the cable until it is dis-
connected.
Switch off the lawnmower, pull the mains plug and wait for the
lawnmower to stop running if, for example:
–
leaving the lawnmower
–
unblocking a blade
–
intending to check, clean or work on the lawnmower
–
you have encountered a foreign object, in which case you
should check the lawnmower for damage and carry out any
necessary repairs.
–
the lawnmower is vibrating heavily (switch off immediately
and ascertain the cause).
–
you wish to change the settings or carry out cleaning work.
–
you wish to check whether the connection cables have be-
come tangled or damaged.

Operation

Operating times
Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
Please feed cable through the strain relief.
Connecting to the mains (230 Volts, A.C., 50 Hz)
The mower operates from any normal household mains sup-
ply, provided with a 16 Amps. fuse.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
Retrofit kits are available for old installations. Consult an elec-
trician.
G
Maintenance
1
Disposal
Setting the working depth
1
The working depth must be set correctly before the unit is usedfor
the first time. When assembling the wheels, ensure that they are
A
assembled in the eorreet positionfor the working depth setting.
Working depth setting when using the unit for the first time is po-
sition 1 of the wheel assembly.
3
Attach grassbox
Lift protective flap, hook grassbox with the hooks provided into the
holes in the chassis (see arrow), reattach protective flap.
–
If the connection cable is damaged during use, it must be
immediately disconnected from the mains power supply.
Do not touch the cable before it has been disconnected
from the mains power supply.
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
Pull out the power plug.
Do not touch running blades.
Do not dispose of electrical equipment in domestic
waste. Recycle equipment, accessories and pa-
ckaging in an environment-friendly manner.
Make sure the motor is switched off and the cutting
blades are not moving.
Information:
Wear on the blades will make it necessary to re-adjust the
depth of cut at a later date. An optimum working depth is ob-
tained when the blades of the cutter are inserted 2-3 mm
into the ground. If the working depth is too deep, this can
overload the scarifier and cause damage. Ensure that the
depth of cut setting is correct.
Unscrew wheels and move to the appropriate height setting.
Screw on wheels tightly.
C
B
11