GYS TIG 168 DC HF Mode D'emploi page 17

MADE IN FRANCE
Adjustable* Hot Start
The 168 HF DC up to 160 A. The TIG 200FV has a limit of 200 A on 230V, and 120 A on 110V.
1- Press and hold the "Hot Start" button.
2- Select the wanted Hot Start.
Nb. : the display «HI» indicates that the Hot Start is at the maximum setting.
Adjustable Arc Force (TIG 200)
The Arc Force is adjustable between 0 and 100% (within the limit of 200A on 230V, 120A on 110V for the TIG 200FV).
1- Press and hold the "Arc Force" button
2- Select the required setting
TIG WELDING
Select Start Function
TIG LIFT: Contact start (for the environments sensitive to HF disturbances)
HF TIG : high frequency start without contact
Trigger behaviour
Compatible Torches
TIG 168 •
TIG 200 •
Nb. : The TIG 200 automatically detects the type of torch that is connected. (Suitable for various kinds of
TIG torches: trigger, single command, dual command, dual potentiometer)
2T mode
4T mode
Nb. : For dual control torches and dual potentiometer
ter active, command «low / cold current» inactive
TIG 168 / TIG 200 DC
1- Select LIFT or HF function.
1- Touch the work-piece with the electrode
2- Press the trigger on the torch
3- Lift the electrode.
•
• •
1- Press and hold the trigger : pre-gas, up slope, welding
2- Release trigger : down slope, post-gas
Nb. : For dual control torches and dual potentiometer
mand "up / warm current" and potentiometer active, command
«low / cold current» inactive
1- Press trigger : pre-gas, followed by start. In order to make position-
ning the electrode easier, a low 10 Amp current is supplied, acting like a
light beam. (=Adjust to Ideal Position)
2- Release trigger : up slope until the displayed instruction, welding
3- Press trigger : down slope until 10A (for a good closure of the crater)
4- Release trigger : stops the current, post-gas.
command "up / warm current" and potentiome-
EN
com-
17