Hurricane H-BM51SD Mode D'emploi D'origine page 26

Anleitung_H_BM_51_SD_SPK7:_
GB
7. Using the petrol lawn mower
Important.
The engine is supplied without oil and petrol.
Therefore, be sure to add oil and petrol before
starting the engine.
In order to avoid any unintentional start-ups of the
lawn mower, it comes equipped with an engine brake
(Fig. 5a/Item 1) which must be pulled back before the
engine can be started. When the engine start/stop
lever is released it must return to its initial position, at
which point the engine automatically switches off.
Move the speed lever (Fig. 6) to position
start/stop lever (Fig. 5b) and vigorously pull on the
starter cable. Move the throttle lever into the "Hare"
position.
Before you start mowing, you should run through this
process several times in order to ensure that the
machine is working properly. Whenever you need to
perform any kind of adjustment and/or repair work on
your lawn mower, wait until the blade has come to a
complete stop. Always switch off the engine before
carrying out any adjustments, maintenance or repairs.
Note:
1. Engine brake (Fig. 5a/Item 1): Use the engine
start/stop lever to switch off the engine. When
you release the engine start/stop lever, the
engine and blade will automatically stop. To mow,
hold the lever in the working position (Fig. 5b).
Before you start to mow, check the start/stop
lever several times to be sure that it is working
properly. Ensure that the tension cable can be
smoothly operated (i.e. is not catching or kinking
in any way).
2. Warning: The blade begins to rotate as soon as
the engine is started.
Important: Before you start the engine, move the
engine brake several times to be sure that the
stop cable is properly working.
Note: The engine is factory set to a speed that is
optimal for cutting and blowing grass into the
basket and is designed to provide many years of
use.
3. Check the oil level.
4. Use a funnel and measuring vessel to fill the tank
with petrol. Make sure that the petrol is clean.
Warning: Never use more than one safety petrol can.
Do not smoke when refueling. Switch off the engine
before refueling and allow the engine to cool down for
a few minutes.
5. Ensure that the ignition cable is connected to the
spark plug.
26
04.11.2010 10:17 Uhr Seite 26
6. Stand behind the mower. Place one hand on the
engine start/stop lever. Place the other hand on
the starter handle.
7. Start the engine using the reversing starter (Fig.
1/Item 7). To do this pull the handle out approx.
10 – 15 cm (until you feel a resistance) and then
start the engine with a sharp pull. If the engine
does not start, pull the handle again.
Important. Never allow the cable to snap back.
Important: In cold weather, it may be necessary
to repeat the starting process several times.
7.1 Before mowing
Important information:
. Pull the
1. Make sure that you are properly dressed when
mowing. Wear sturdy footwear; do not wear
sandals or tennis shoes.
2. Inspect the blade. Blades, that are bent or
otherwise damaged, must be exchanged for a
genuine Einhell replacement blade.
3. Do not fill the fuel tank indoors, but rather out in
the open. Use a funnel and a measuring vessel.
Wipe off any spilled petrol.
4. Read and follow in the instructions in the
operating manual as well as the information
regarding the engine and accessory equipment.
Store the manual in a place where it can be
readily accessed by other users of the machine.
5. Exhaust gas is dangerous. Only start the engine
out in the open.
6. Make sure that all the guards are fitted and that
they are in good working order.
7. The machine should only be operated by persons
who are well informed with the way it works and
who are in reasonably good physical condition.
8. Mowing wet grass can be dangerous. Mow the
grass when it is as dry as possible.
9. Tell other persons and children to stay away from
the mower.
10. Never mow in conditions of poor visibility.
11. Pick up any loose objects and debris on the lawn
prior to mowing.