TFA 60.2558 Mode D'emploi page 13

TFA_No. 60.2558_Anleitung
Radio-controlled alarm clock
B 2: SNOOZE/LIGHT button
B 3: ALARM SET button
B 4: – button
B 5: + button
B 6: TIME SET button
B 7: LOCK ON / OFF
C: Housing (Fig. 3):
C 1: Battery compartment
4. Getting started
• Open the battery compartment and insert two new AAA 1.5
V batteries, polarity as illustrated.
• Close the battery compartment again.
• The device will alert you with a beep and all segments will
be displayed for a short moment.
24
26.09.2019 17:34 Uhr
switch
Seite 13
Radio-controlled alarm clock
5. Radio-controlled time reception
• The clock will now scan the DCF frequency signal and the
DCF symbol flashes on the display. When the time code is
successfully received after 3-8 minutes, the radio-con-
trolled time, the date, the day of the week and the DCF
symbol will be shown steadily on the display.
• You can also start the initialization manually.
• Press and hold the – button for two seconds.
• The DCF reception symbol will be flashing.
• Interrupt the reception by pressing the – button again for
two seconds. The DCF reception symbol disappears.
• The DCF reception always takes place daily at 2:00 o'clock
in the morning. If the reception is not successfully re-
ceived, the next DCF reception attempt will happen at 3:00
o'clock in the morning.
• If the clock cannot detect the DCF-signal (e.g. due to inter-
ference, transmitting distance, etc.), the time can be set
manually. The clock will then work as a normal quartz
clock (see: Manual settings).
25