Télécharger Imprimer la page

Hoshizaki KM-1301SAH-E Notice D'installation page 4

Masquer les pouces Voir aussi pour KM-1301SAH-E:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
ENGLISH
(d) Make sure the left side and bottom of the
assembly are flush against the wall and base
panel.
(e) Secure the assembly into place with the
thumbscrews (unless you are installing
a second unit). (See "5. Stacking Two
Icemakers.")
(f) Insert the plug into the receptacle on the
assembly until it locks into place.
(g) Remove the two screws from the lower part of
the thermostat bracket (plastic) and use them
to attach the thermostat extension bracket
(stainless) to the thermostat bracket (plastic).
Thermostat Extension Bracket
(stainless)
Fig. 3b
6) Level the icemaker and storage bin in both the
left-to-right and front-to-rear directions. Adjust the
storage bin legs to make the icemaker level.
7) Replace the panels and baffle in their correct
positions (unless you are installing a second unit).
(See "5. Stacking Two Icemakers.")
5. Stacking Two Icemakers - See Fig. 4 and 5
1) See "4. Installation" for the lower unit installation.
2) Remove the top panel and the top insulation of the
lower unit. The top panel and the top insulation of
the lower unit are not required when installing the
second icemaker.
3) Unpack the second icemaker (upper unit), and
remove the shipping carton, tape, and packing
material.
4) Remove the panels of the second icemaker.
5) Stack the upper unit on top of the lower unit.
6) Secure the upper unit to the lower unit using the
two mounting brackets and the bolts provided.
Mounting
Brackets
Bolts
Mounting
Brackets
7) Remove the tie securing the upper unit's bin control
thermostat assembly.
8) Remove the bin control thermostat assembly from
Thermostat Bracket
the shipping hook by lifting it up and shifting it to
(plastic)
the right.
9) Remove the thermostat bulb attachment of the
upper unit from the thermostat extension bracket
(stainless).
10) Carefully remove the thermostat bulb from the
thermostat bulb attachment of the upper unit.
11) Carefully route the thermostat bulb and capillary
tubing of the upper unit through the bottom hole of
the upper unit. Remove the bushing from the lower
bin control thermostat assembly. Route the bulb
and tubing through the hole in the assembly and
down into the bin. Reattach the bushing.
12) Secure the lower bin control thermostat assembly
in place with the thumbscrews.
13) Carefully insert the thermostat bulb back into the
thermostat bulb attachment.
14) Secure the thermostat bulb attachment of the upper
unit to the thermostat bulb attachment of the lower
unit with the screws of the upper unit.
15) Insert the plug of the upper unit into the receptacle
of the upper unit's bin control thermostat assembly
until it locks into place.
16) Replace the panels and baffle in their correct
positions.
4
Icemaker
(Upper
Unit)
Icemaker
(Lower
Unit)
Bin
Fig. 4

Publicité

loading