Rittal CMC III Notice D'installation Et D'utilisation page 8

EN
Notes on documentation, Safety instructions, Product description
1 Notes on documentation
This installation and short user guide is intended for experienced trained specialists and contains only
EN
the most important information concerning the assembly, installation and function of the CMC III Uni-
versal Sensor (subsequently called universal sensor).
1.1 Associated documents
CMC III Universal Sensor assembly and operating instructions.
It is available at www.rittal.com and contains the complete application-relevant information and techni-
cal data for the universal sensor with regard to:
– Further assembly possibilities
– Functions
– Configuration possibilities
– Detailed operating instructions
– Troubleshooting
2 Safety instructions
– Assembly and installation of the universal sensor may only be performed by experienced trained spe-
cialists.
– The universal sensor housing must not be opened.
– The universal sensor must not come in contact with water, aggressive or inflammable gases and va-
pours.
– The universal sensor must only be operated within the specified environmental conditions (see
section 3.4).
3 Product description
3.1 Functional description
The universal sensor has the following interfaces:
– Two digital inputs
– Analogue input 4-20 mA
– Two S
0
– One Wiegand interface 56 bit or 86 bit
The interfaces can be configured from the CMC III PU web site. The universal sensor provides the val-
ues measured by this sensor to the connected CMC III PU. It has an identification that allows it to be
detected automatically by the CMC III PU.
3.2 Proper use
The CMC III Universal Sensor is used only to acquire data using one of the available interfaces. It may
be used only together with the CMC III PU. Any other use is not permitted.
3.3 Scope of delivery
– CMC III Universal Sensor
– Accessories supplied loose (fig. 1)
– Installation and Short User Guide
8
bus energy meters
Rittal CMC III Universal Sensor