Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Location of rating plate
WARNING
If the information in this manual is not followed exactly, a fire
or explosion may result causing property damage, personal
injury or death.
Introduction
Please read these instruction COMPLETELY AND CAREFULLY.
They will save you time and effort and help to ensure optimum
oven performance.
Be sure to observe all WARNINGS. These installations are
intended for use by a qualified installer.
In addition to these instructions, the oven shall be installed:
• In the United States, in accordance with the National Electric
Code/State and Municipal codes and/or local codes.
• In Canada, in accordance with Canadian Electric Code
C22.1- latest edition/Provincial and Municipal codes and/
or local codes.
These shall be carefully followed at all times.
NOTE: IF INSTALLING YOUR OVEN IN CANADA PLEASE
CHECK TO MAKE SURE THAT YOU HAVE A MODEL WITH THE
CANADIAN LISTING.
MARK, AS SHOWN ABOVE:
Mark as shown above means the oven complies with both US
and CANADIAN Standards.
Tools you will need
The following tools are needed to install your new oven:
• Tape measure and straight edge or rules
• Pencil
• Phillips screwdriver
18 - Installation instructions
• Level
• Wire cutters and wire stripper
• Hand or saber saw
• 1" (2,5 cm) Hole saw
• Drill and drill bit
• Safety gloves and goggles
• Volt meter (0-250VAC)
Packaging
Remove all tape and packaging before using the oven.
Destroy the packaging after unpacking the oven following the
rules in force in your town. Never allow children to play with
packaging material.
Power requirements
The oven must be supplied with the proper voltage and
frequency. The oven is manufactured to be connected to a
three-wire, single phase,120/240V, 60 Hz AC electrical supply
on a separate circuit fused in both sides of the line. A circuit
breaker or time delay fuse sized
not to exceed the circuit rating of the appliance specified on
the rating plate located on the frame behind the door of the
oven is recommended.
The oven must be supplied with copper or aluminum wires.
If aluminum wire is provided to connect oven to branch circuit,
UL listed connectors for joining copper and aluminum must be
used. Follow instructions provided with connectors.
If is recommended that you have the electrical wiring and
hook-up of your oven performed by a qulified electrician.
After installation is complete have the electrician show you
where the main disconnect is and which of the circuit breakers/
fuses are for the oven.
Choosing oven location
Carefully select the location where the oven will be placed.
The oven should be located for convenient use in the kitchen,
but away
from strong drafts.
Strong drafts may be caused by open doors or windows, or
by heating and/or air conditioning vents or fans. Make sure
that electrical power can be provided to the location selected.
Steps for installation
The following pages provided the necessary information for
proper installation of the oven and are arranged as follows:
• Technical Data
• Installation Cutout Dimensions, Required Clearances and
Mounting instructions for:
- Under counter installation, Single Oven
- Wall installation, Single Oven
• Electrical supply and Wiring Requirments, programming
not required if connecting to 120/208 Volt circuit. Electrical
Connections for 3-wire or 4-wire Branch Circuit.
• Final Checklist.
EN
29
Publicité
Chapitres
Table des Matières
