Trouble Shooting; Spare Parts - Grizzly ERM 1434 G Mode D'emploi

GB

Trouble Shooting

Problem
Equipment does not
start
Motor stops
Result unsatisfactory
or motor labours
Blade fails to turn
Strange noises, rat-
tling or vibrations

Spare parts

When ordering spare parts, please use the indicated Service-Center address or fax
number. Please indicate the part number with your order.
Spare blade ....................................................................................................91095689
Grass catcher ..................................................................................................91095709
28
Possible Cause
Power is off
Defective on/off switch
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object Remove the foreign object
Cut height too low
Blade blunt
Blade area blocked
Blade assembled incor-
rectly
Blade blocked by grass
Blade screw loose
Blade screw loose
Blade damaged
Fault Fixing
Check the socket, cable, wire and
plug and have any repairs carried
out by an electrician
Repair by customer services
Set a greater cut height. Lift the
front wheels slightly by pressing
down on the handle bar.
Set a higher cut height
Have the blade sharpened or re-
place it
Clean the equipment
Install the blade correctly
Remove the grass
Tighten the blade screw
Tighten the blade screw
Replace the blade