Adjusting The Sync And Subcarrier Phases - Sony DSR-40 Mode D'emploi

Adjusting the Sync and Subcarrier Phases

DSR-40/40P (player 1)
COUNTER AUDIO
TIMER
INPUT SELECT MONITOR
SELECT
TC CH-1/2 REPEAT
COUNTER MIX OFF
TAPE CH-3/4 REC
REMAIN
UVW-1600/1600P (player 2)
Note
44 GB
Chapter 3 Using the Unit as a Player in an Editing System
When using two or more players, as in an A/B roll editing system, phase
synchronization of the signals (i.e. system sync) is necessary and for
composite signals only, the subcarrier phase must also be in sync. If not,
picture instabilities or color break-up may occur at edit points.
After configuring the editing system, use a vectorscope to adjust the sync
and subcarrier phase of the recorder and players. Subcarrier phase
adjustment is necessary when using composite signals or Y/C signals.
DUP
Switcher
REMOTE
MENU
LOCAL
SET
BLACK
BURST
OUT
PVE-500 Editing control unit
Note
The sync and subcarrier phase of the output signal from the DFS-500/
DFS-500P Switcher are automatically adjusted.
DSR-85/85P (recorder)
PGM OUT
75 Ω coaxial cable (B)
A IN
75 Ω coaxial cable (A)
B IN
REF. VIDEO
EXT IN
Note
Ensure that the 75 Ω coaxial cables (A)
and (B) are of the same length.
Vectorscope (Tektronix
1750/1751, etc.)