Location And Function Of Parts; Front Panel - Sony DSR-40 Mode D'emploi

Location and Function of Parts

Location and Function of Parts

Front Panel

1 Cassette compartment
2 ON/STANDBY switch
and ON/STANDBY lamp
1 Display section
(see page 11)
3 PHONES jack
4 PHONE LEVEL control knob
5 AUDIO INPUT LEVEL control knobs
1 Cassette compartment
Accepts standard-size or mini-size DVCAM digital
videocassettes. When using a mini-size cassette, insert
it into the center of the compartment.
For details of usable cassettes, see page 8.
2 ON/STANDBY switch and ON/STANDBY lamp
Press this switch to turn on the power, and the ON/
STANDBY lamp lights in green. Press it again to turn
to standby mode, and the lamp lights in red.
Note
When the REMOTE/LOCAL switch is set to
REMOTE, you cannot turn the unit to standby mode.
3 PHONES jack (stereo minijack)
Connect stereo headphones for headphone monitoring
during recording or playback.
The audio signal you want to monitor can be selected
with the AUDIO MONITOR selector inside of the
door (3).
10 GB
Chapter 1 Overview
DUP
COUNTER AUDIO
TIMER
INPUT
SELECT MONITOR
REMOTE
SELECT
TC CH-1/2 REPEAT
MENU
COUNTER MIX OFF
TAPE CH-3/4 REC
REMAIN LOCAL
SET
4 PHONE LEVEL control knob
Controls the volume of the headphones connected to
the PHONES jack.
5 AUDIO INPUT LEVEL control knobs
When recording, you can use these knobs to set audio
input levels for CH-1 (channel 1) and CH-2 (channel
2), respectively.
6 COUNTER RESET button
Press this button to reset the tape counter in the display
window to "0:00:00 (0
work when displaying the time code or the remaining
time.
7 EJECT button
Press this button to eject a cassette.
6 COUNTER RESET
button
2 Tape transport
control section
(see page 12)
7 EJECT button
3 Inside of the door
(see page 13)
00 00 )". This button does not
H M S