Operation; Using The Hand Element With The Handle; Using The Hand Element; Cleaning And Care - SilverCrest SHSS 12 C2 Mode D'emploi

Masquer les pouces Voir aussi pour SHSS 12 C2:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Operation

ATTENTION! MATERIAL DAMAGE!
The suction opening must always be open and
unblocked. Blockages lead to overheating and
damage to the motor.
Do not vacuum shag pile carpet with the floor
nozzle. The rotary brush
the carpet and block!
NOTE
Make certain that the dust filter
coarse filter
are always inserted before
using the appliance.
As soon as the suction power of the appliance
begins to diminish noticeably, connect the
appliance to the charger
Using the hand element with the
handle
1) Insert the hand element
element recess
"Assembly/disassembly".
2) Fold out the grip
release
and at the same time pulling the
grip
upwards.
3) Switch on the appliance using the on/off
switch
. The LED lamp
will illuminate and the rotary brush
turning.
4) Guide the floor nozzle over the area to be
vacuumed. Hold the grip
nozzle moves smoothly over the floor.
5) Press the on/off switch
finished vacuuming. The rotary brush
and the LED lamp
SHSS 12 C2
can get caught in
and the
.
into the hand
as described in the chapter
by pressing the "Grip"
on the floor nozzle
starts
so that the floor
when you have
goes out.

Using the hand element

1) Remove the hand element
element recess
"Assembly/disassembly".
2) As required, attach the crevice tool
brush nozzle
3) Set the on/off switch
desired areas.
4) When you have finished vacuuming, press the
on/off switch

Cleaning and care

WARNING! RISK OF INJURY!
Always disconnect the charger
mains socket and remove the barrel jack
from the charging socket
before cleaning the cradle
Always remove the hand element
hand element recess
cleaning the hand element
the rotary brush
To achieve the best results, empty the dirt container
and clean the dust filter
ATTENTION! MATERIAL DAMAGE!
Do not use abrasive or aggressive cleaning
materials. These could damage the surface
of the appliance!
NOTE
The LED lamp
The LEDs cannot be changed.
stops
from the hand
as described in the chapter
, the
or the upholstery nozzle
to start vacuuming the
again.
from the
on the cradle
.
from the
on the handle before
, the handle or
.
after every use.
is maintenance-free.
GB │ IE │ NI
.
 7

Publicité

Table des Matières

Dépannage

loading

Table des Matières