NOTES:
Inputs, regardless of the mixing level shown in this screen, must be enabled (LED
indicator lit in blue) for this zone mix to be effective. From this screen or from the zone volume
main screen, you can press input keys to enable or disable the corresponding inputs in the
mix
From the MIXER screen, short presses on the same digital encoder (for the displayed
output) will alternate between the MIXER screen and the main screen of the zone
From the MIXER screen of a zone, you can switch to the MIXER screen of any other
zone, briefly pressing a front panel ZONE encoder (A, B, C or D)
6.3. RECALL PRESET MENU
The DAM614 has 9 operating templates, which are used as a starting point for the configuration
of an operating mode
o T1:
4 stereo inputs
o T2:
4 stereo inputs
o T3:
4 stereo inputs
o T4:
3 stereo inputs + 2 mono inputs
o T5:
3 stereo inputs + 2 mono inputs
o T6:
3 stereo inputs + 2 mono inputs
o T7:
2 stereo inputs + 4 mono inputs
o T8:
2 stereo inputs + 4 mono inputs
o T9:
2 stereo inputs + 4 mono inputs
Each system template automatically sets the operating and control mode of the channels and
their settings, including the stereo linked group they pertain to. Example: in a stereo input or output
configuration, the settings applied to the left channel are also automatically applied to the right channel,
and vice versa
It is therefore possible to recall one of these templates, to edit its parameters and save the
resulting setup as a PRESET or user memory.
System templates are displayed on the screen with the Txx prefix, where xx is the template
number (between 01 and 09), followed by its name or LABEL. These files are not rewritable.
16
x
4 mono outputs
x
2 stereo outputs
x
1 stereo output + 2 mono outputs
x
4 mono outputs
x
2 stereo outputs
x
1 stereo output + 2 mono outputs
x
4 mono outputs
x
2 stereo outputs
x
1 stereo output + 2 mono outputs