Main Screen/Mixer Mode/Preset Management; Main Screen - Ecler DAM614 Notice D'utilisation

6. MAIN SCREEN/MIXER MODE/PRESET MANAGEMENT

6.1. MAIN SCREEN

After power on, the screen of the device displays the following information for a few seconds...
...then shows other information similar to this one:
Z A
P 0 1
The information available on this screen, or main screen, is as follows (according to the example
above:

ZA: selected output zone for volume adjustment, selection of sources, etc. The available
zones are ZA, ZB, ZC, ZD (all mono) or ZAB and ZCD if any pair of outputs is configured
as a stereo zone

OUTPUT 1: name of the output zone, by default OUTPUT n, but it is editable

P01: number of the active preset or template. An asterisk to the right of the preset number
indicates that this preset has been modified and not yet re-saved in the DAM614 memory
(your changes will be lost when you shut down the computer if they are not saved
before...)

Horizontal Volume Bar: displays the output volume of the relevant zone; it can be directly
altered by rotating its digital encoder. The LED indicator of the targeted output briefly
flashes when its level is altered by rotating the digital encoder.
When a unit's input or output has been assigned to a volume control from an external wall panel
(WPm series or similar) connected to a REMOTE port of the DAM614 back panel, any modification of
the physical remote panel position will briefly display the relevant volume setting on the LCD screen
(before returning to the previous screen):
14
D A M 6 1 4
L O A D I N G . . .
O U T P U T
R E M O T E
1
2