Mixer Mode - Ecler DAM614 Notice D'utilisation

In addition, the input and output LED indicators light up on the front panel to give the following
information:

Inputs:
Input enabled for the output zone displayed on screen (LED On). A short press on the
encoder switches its status (active/inactive)
Input disabled for the output zone displayed on screen (LED Off). A short press on
the encoder switches its status (active/inactive)

Outputs:
Muted Output (MUTE = ON) (LED lit in red). A long press (> 2 seconds) on the
encoder switches its status (unmuted/muted)
Unmuted output (MUTE=OFF). A long press (> 2 seconds) on the encoder switches
its status (unmuted/muted)
Note: you can press multiple encoders simultaneously to enable/disable their MUTE
function

6.2. MIXER MODE

From the main screen of a zone (indicating its name and its output volume with a bar indicator), a
short press of this output digital encoder switches your display to the MIXER mode:
Z
C
In this mode, it displays the mixing level of each input for the output displayed in the main screen
(and in the upper left corner of the MIXER mode screen).
In the example above, we see the following information:

The displayed output zone is ZONE C

The mixing level of the inputs for this zone is 99 (INPUT1), 50 (INPUT2), 50 (INPUT3), 64
(INPUT4), 99 (INPUT5) and 74 (INPUT6)
This mix levels, concerning the inputs routed to the output ZONE C, are totally independent of the
mixing volume of the same inputs for the 3 other zones of the device (A, B and D).
In this screen, you can change these mixing levels by rotating each input digital encoder. The
LED indicator of the targeted input briefly flashes when its level is altered by rotating the digital encoder.
I 1 I 2 I 3
9 9 5 0 5 0
I 4 I 5 I 6
6 4 9 9 7 4
15