Kenwood JMP80 Mode D'emploi page 6

Masquer les pouces Voir aussi pour JMP80:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
This appliance shall not be used by children. Keep the
l
appliance and its cord out of reach of children.
Misuse of your appliance can result in injury.
l
Do not let the cord touch hot surfaces or hang down where a
l
child could grab it.
Appliances can be used by persons with reduced physical,
l
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and if they
understand the hazards involved.
Only use the appliance for its intended domestic use.
l
Kenwood will not accept any liability if the appliance is subject
to improper use, or failure to comply with these instructions.
before plugging in
Make sure your electricity supply is the same as
l
the one shown on the underside of the appliance.
WARNING: THIS APPLIANCE MUST BE
l
EARTHED.
This appliance conforms to EC Regulation
l
1935/2004 on materials and articles intended to
come into contact with food.
before using for the first time
Wash the parts: see 'care and cleaning'.
key
pusher
1
feed tube lid latch
2
lid with feed tubes
3
scroll
4
filter basket (red dot)
5
rotating wiper holder
6
juicing bowl
7
pulp spout
8
pulp container
9
power unit
bk
juice spout
bl
anti-drip stopper
bm
On/Off/Reverse switch
bn
juice jug
bo
cleaning brush
bp
sorbet attachment (if supplied)
bq
smoothie attachment (white dot) (if supplied)
br
using your juicer
1 Fit the pulp stopper
underside of the juicing bowl
(B)
until secure
.
2 Fit the juicing bowl
positioning the juice spout to the front
3 Place the filter basket
(D)
.
6
4 Lower the wiper holder assembly into the juicing
bowl and align the red dot on the filter basket
with the red dot on the bowl
the filter basket is locked into place.
5 Place the scroll
4
down and turn slightly to secure
the lid cannot be fitted if the scroll is
not fully pushed down.
6 Fit the lid
onto the bowl by aligning the red
3
dot on the lid with the red dot on the bowl
Then turn to lock in a clockwise direction
until the
on the lid aligns with the red dot on
(I)
the bowl
and the
top of the power unit
7 Place the pulp container
spout
and place the juice jug
8
juice spout
. Ensure the anti-drip stopper
bl
if fitted is in the open position
The anti-drip stopper can be left in the closed
l
position if you want to mix different fruits and
vegetables. Do not allow the juice to exceed the
maximum capacity marked on the bowl when
operating the juicer with the stopper closed as
the juice may overflow.
3
(A)
into the opening on the
and push in
7
to the power unit by
7
red dot graphic
(C).
into the wiper holder
5
down arrow graphic
white arrow graphic
triangles graphic
(E)
. Ensure that
into the filter basket, push
(F)
. Note:
red dot graphic
down arrow graphic
aligns with the
(J)
on graphic
.
white arrow graphic
under the pulp
9
reverse graphic
under the
bo
triangles graphic
off graphic
(K)
before juicing.
red d
down
(G)
.
(H)
white
on
triang
bm
on gr
rever

Publicité

Table des Matières
loading

Table des Matières