Duox Plus Amplifier Calling Codes; Calling A House From The Direct Panel - Fermax DUOX PLUS Manuel D'installation Et De Programmation

ENGLISH

DUOX PLUS Amplifier Calling Codes.

The DUOX PLUS system uses 6 digit house terminal addresses. This provides a lot of
flexibility when numbering terminals in each country´s established numbering system.
These call code digits are organised as follows: BBSSNN:
· BB indicates block number.
A block is a group with a maximum of 9999 residences. The value ranges from BB=00 to
99, so up to 100 blocks may be available.
· SS indicates sub-block number.
A sub-block is part of a block which you may want to sub-divide for organisational
purposes. This is equivalent to an MDS block. Each sub-block may contain 99 terminals
and up to 100 sub-blocks (SS=00..99). A sub-block may be a building, a story in a building
or a housing complex area.
· NN indicateshouse number in the sub-block.
It may range from 00 to 99.
You do not have to segregate the installation according to this hierarchy since the system
adapts to the installation´s needs.
The outdoor panels may be configured as follows, (See «Outdoor panel configuration»):
· General Entrance [G]. This allows for a calling range from 000001 to 999999.
· Block entrance [B]. This allows for a calling range from 0001 to 9999.
· Sub-block entrance [S]. This allows for a calling range from 01 to 99.
Each panel may also have a different number on each block, sub-block or general entrance,
which goes from 0 to 9. The default value is 0.
· The house terminal´s address is encoded with 6 digits (calling code). The default value is
000000, (this can´t be called from any outdoor panel).
· Panels with an address "0" in each block allow for communication with telephones when
picked-up if the communication line is free. Communication is established with the "0"
panel of the block corresponding to the telephone. If you do not want this feature do not
assign this address to any panels.
· A telephone with the address 000000 can not establish communication upon being picked-
up.
· If there are panels in the sub-block, no connection is made upon picking-up, only with the
block´s panel 0.

Calling a house from the Direct Panel.

Enter the house number via the keypad and press .
The last 6 digits entered before pressing% are noted. Depending on the outdoor panel´s
configuration and the digits entered, you may make the call or not.
Upon programming each phone, it inherits the upper part of the address the outdoor panel
has assigned, if it isn´t a general entrance panel.
Pag 42