Télécharger Imprimer la page

HQ Power VDPLOC OCTOSTRIP Notice D'emploi page 7

Publicité

Les langues disponibles
  • FR

Les langues disponibles

o Projector DMX Start Address Selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDPLOC.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the VDPLOCs will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you set
different addresses, each device will "listen" to a separate channel number. Changing the settings of one channel will
only affect the device in question.
In the case of the 48-channel VDPLOC, you will have to set the start address of the first VDPLOC to 1, the second
VDPLOC to 49 (1 + 48), the third to 49 (97 + 48) and so on.
• DMX Black-Out
Press the mode button to view Ndl1 menu. Press F / S and go to d-oF. Select d-oF or d-on with up or down.
When d-on is selected, the light output will be switched off when pressing the black-out button on the DMX
console.
When d-oF is selected, the light fixture will run a chase when pressing the black-out button on the DMX console.
Note: d-on is factory preset.
7. Mounting Bracket
Refer to the picture at the end of this manual to assemble or to disassemble the mounting bracket.
8. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts apart from the fuse.
8. Contact your dealer for spare parts if necessary.
9. Technical Specifications
Controller
Power Supply
Power Consumption
Fuse
Control
Dimensions
Total Weight
Lighting Strip
Power Supply
Power Consumption
VDPLOC
max. 230VAC / 50Hz
max. 200W
5A, 250VAC (5 x 20mm) (order code FF5N)
DMX, sound control or stand-alone
360 x 200 x 95mm
5.150kg
24V (via controller)
14W per strip
7
HQPOWER

Publicité

loading