Briteq BT-700S Mode D'emploi page 7

ENGLISH
Color 1 offset
 Press ENTER for at least 12 seconds to go into offset mode and turn the jog wheel until Color 1 Offset is
shown on the display
 Press the ENTER button so the display starts blinking.
 Use the jog wheel to adjust the home position of color wheel 1
Color 2 offset
 Press ENTER for at least 12 seconds to go into offset mode and turn the jog wheel until Color 2 Offset is
shown on the display
 Press the ENTER button so the display starts blinking.
 Use the jog wheel to adjust the home position of color wheel 2.
Gobo 1 offset
 Press ENTER for at least 12 seconds to go into offset mode and turn the jog wheel until Gobo 1 Offset is
shown on the display
 Press the ENTER button so the display starts blinking.
 Use the jog wheel to adjust the home position of gobo wheel 1.
Gobo Rotation offset
 Press ENTER for at least 12 seconds to go into offset mode and turn the jog wheel until R-Gobo Offset is
shown on the display
 Press the ENTER button so the display starts blinking.
 Use the jog wheel to adjust the home position of gobo rotation.
Gobo 2 offset
 Press ENTER for at least 12 seconds to go into offset mode and turn the jog wheel until Gobo 2 Offset is
shown on the display
 Press the ENTER button so the display starts blinking.
 Use the jog wheel to adjust the home position of gobo wheel 2.
Prism offset
 Press ENTER for at least 12 seconds to go into offset mode and turn the jog wheel until Prism Offset is
shown on the display
 Press the ENTER button so the display starts blinking.
 Use the jog wheel to adjust the home position of the prism.
Prism Rotation offset
 Press ENTER for at least 12 seconds to go into offset mode and turn the jog wheel until R-Prism Offset is
shown on the display
 Press the ENTER button so the display starts blinking.
 Use the jog wheel to adjust the home position of Prism Rotation.
Iris offset
 Press ENTER for at least 12 seconds to go into offset mode and turn the jog wheel until Iris Offset is
shown on the display
 Press the ENTER button so the display starts blinking.
 Use the jog wheel to adjust the home position of the iris.
BRITEQ
®
OPERATION MANUAL
9/72
ENGLISH
HOW TO CONNECT THE UNIT BY DMX
The DMX-protocol is a widely used high speed signal to control intelligent light equipment.
You need to "daisy chain" your DMX controller and all the connected light effects with a good
quality XLR M/F balanced cable. To prevent strange behavior of the light effects, due to
interferences, you must use a 90Ω to 120Ω terminator at the end of the chain. Never use Y-
splitter cables, this simply won't work!
Each light effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode
.
 HOW TO SET THE THE RIGHT STARTING ADDRESS:
Refer to the previous chapter (DMX-512 address setting) to learn how to set the starting address on this unit.
The starting address of each unit is very important. Unfortunately it is impossible to tell you in this user
manual which starting addresses you have to set because this completely depends on the controller you will
use... So please refer to the user manual of your DMX-controller to find out which starting addresses you
must set.
BT700S BRITEQ
®
OPERATION MANUAL
10/72 BT700S