Peg-Perego belted base Notice D'emploi page 7

Instructions for use in vehicle
WARNING: once screwed on, the anti
rebound bar must never be removed as it
forms an integral part of the product.
1• Pull the seatbelt's waist strap through the
two side routers of the base, making sure it
is taut, and fasten the seatbelt to the seat as
shown.
2• Place the car seat on the base in a rear
facing position.
To fasten the car seat to the base, press down
on the product until it clicks into place.
Place your child in the car seat,
remembering to secure him or her with the
safety harness.
3• Take the vehicle's seatbelt and pull it behind
the car seat's backrest. Slide it through
the routers on the rear of the backrest and
make sure it is taut, as shown.
4• To release the car seat from the base, you
must: release the vehicle's seatbelt and
remove it from the routers on the rear of the
backrest;
5• press the lever on the car seat's backrest
upwards and simultaneously lift the car
seat.
The base remains fastened on the vehicle's
seat, ready for use.
Serial numbers
This information is required for any
complaints.
Cleaning and maintenance
How to read the approval label
PEG-PÉREGO S.p.A.