Publicité
INSTRUCTIONS FOR USE
DISPLAY
CAUSE
INDICATION
E03
Internal overheating of battery
charger. Battery charger overload.
E04
Voltage error.
One or more elements of the battery
has/have short-circuited.
E05
Battery voltage too high compared
to that set (you are attempting to
charge a 24V battery).
E06
Battery capacity excessive
Unable to reach end condition.
E07 and LED
The clamps of the output leads
REVERSE
are not connected correctly to the
battery.
E08
Excessively high output current
Current exceeds maximum limit
WARNINGS
• The battery charger is designed to charge lead acid batteries. Do not use it for any other purposes. Do not charge disposable
batteries. Do not charge frozen batteries.
• This appliance must not be used by incapable persons (including children) without supervision.
• Keep out of the reach of children. This appliance is not a toy and must not be used as such.
• Always wear protective goggles and keep your face away from the battery while connecting and disconnecting it.
• Explosive gas could be given off while the battery is charging; therefore, prevent the formation of sparks or flames,
and do not smoke.
• Charge the battery in well-aired and dry places. Do not expose to rain or snow.
• Make sure the battery charger is disconnected from the mains before connecting, or disconnecting, the charge leads to/from
the battery.
• Never put the battery charger on top of the battery while charging it.
• The fluid in the batteries is corrosive. In case of accidental contact between the acid and the skin or eyes, rinse with water
immediately and seek medical advice.
• Improper use of the battery charger or tampering with the built-in electronic circuit will invalidate your warranty.
• If the power supply lead of the appliance is damaged, it must be replaced by authorized technicians, because its replacement
requires the use of special tools.
• The appliance must be repaired or serviced by trained personnel only.
• Read the instruction manual carefully before using the battery charger.
SOLUTION
Remove any objects that could be covering the ventilation area
of the battery charger or move it to a cooler area. Wait for the
battery charger to start again automatically.
Set the voltage corresponding to that of the battery again.
Start charging the battery again (see section "Operating the
Charger").
The battery could be defective. Contact your nearest battery
service centre.
Only use the battery charger with batteries supported at 12V.
Start charging the battery again (see section "Operating the
Charger").
Use a battery charger with greater capacity.
Position the clamps correctly and start charging the battery
again (see section "Operating the Charger").
Reduce battery absorption.
EN
13
Publicité
