Publicité
Les langues disponibles
Les langues disponibles
Found" message appears.
The PC or monitor no longer works.
The table glass 13) is broken or
scratched.
A part of the "V" tool holder 12) is defec-
tive.
The handwheel of the micrometer screw
of the Rotary 50 no longer drives the
stop.
A clutch 8) or 18) of table 14) no longer
works.
Software problem.
For any other case, please contact us
by referring to the serial number listed in
16).
rotatif$24.docx
2. Check that the camera cable 1) is correctly
screwed onto the camera and correctly
pushed in on the computer side.
3. Connect the camera cable 1) to another port
(usually blue for USB3 models).
4. Check by disconnecting it that a device con-
nected to the computer (external disc, loud-
speaker, etc.) does not interfere with the
camera signal.
5. Refer to our "OptiVID" operating instructions
6. If this is not enough; contact our technical
department.
1. Check that the cables are correctly inserted in
the plugs.
2. If this is not enough; contact your IT depart-
ment or, if necessary, our technical depart-
ment.
Order a spare glass.
Rotatif 50 : VER-006113.
Rotatif 150 : VER-000078.
Rotatif 200 : VER-007974.
Refer to our operating instructions «
Pro
»
The micrometer screw flange screw is too tight.
Loosen it completely and then tighten to a maximum
of 1.5N.
Order a spare clutch
Rotary 150: MEC-011889
Rotary 200: Contact our technical department.
1. Press the F1 key on your keyboard and refer
to the online help.
2. Disable the screensaver and automatic log-
out.
3. Turn off your PC completely, wait
for ten seconds and turn it back on.
4. If this is not enough; contact your IT depart-
ment or, if necessary, our technical depart-
ment.
Tél: +41 (0)32 365 51 31
Fax: +41 (0)32 365 76 20
Email:
info@marcel-aubert-sa.ch
Concentricity
20
Publicité
