marcel aubert Rotatif 50 Mode D'emploi page 18

5) Zoom position wheel
6) Episcopic LED ring light
7) Handwheel X axis
8) Disengagement of the X axis
9) Diascopic LED lighting (lighting from below)
10) Z-axis handwheel
11) Precision column
12) "Concentricity
13) Table glass
14) Measuring table
15) Granite base
16) Machine identification
17) Levelling foot
18) Y-axis disengagement
19) Y-axis crank handle
20) Measuring ruler box XYZ
21) Jack connector for power supply of scales (only in XYZ version)
22) USB2 B connector for the computer
23) SUB-D connector for measuring scale of the X axis of the table
24) SUB-D connector for measuring scale of the Y axis of the table
25) SUB-D connector for measuring scale of the Z axis of the column
26) Lighting control;
diascopic
27) Horizontal optics
28) Opal filter
29) Angular index
30) Rotation lever
31) Angular positioning finger
32) Angular step
33) Part to be checked
General use
 Calibration : Make sure your device is properly calibrated. To do this, please use the instruc-
tions for the software.
 Software : Use the F1 key for online help or refer to our "Quick start" or "Instructions for Use"
documents.
 Zoom lens 3), 27) : Turn the knob 5) to change the magnification. The zoom positions are in-
dexed. You should therefore feel a "click" when you are in the required position. A sticker on
the zoom allows you to know your position. Make sure you are on the same position in your
software. For more information, please refer to the operating instructions «
 Sharpness: Place the part to be measured on the glass 13) of the measuring table 14) and
use the crank 10) to adjust the sharpness of the image.
rotatif$24.docx
Pro" tool holder
MA 356-042-02 box for vertical episcopic + horizontal episcopic +
OptiVID ».
18