marcel aubert Rotatif 50 Mode D'emploi page 15

Danger of electrical shock!
Caution
Start-up
Base
Tables Rotatif 150 & 200
Table Rotatif 50
Rotatif 50
rotatif$24.docx
 Do not open the enclosure.
 Never use 3-wire to 2-wire adapters.
 The insulating jacket of the cable shouldn't have any defects
General safety precautions must be followed when operating this
electrical equipment. Not following these precautions could damage
the equipment or injure personnel.
Safety rules vary between companies. If a conflict exists between the
content of this guide and the rules of the company using this system,
the more stringent rules should be applied.
A) Check the levelling of the machine by adjusting the levelling
feet.
B) Remove the red safety plates on the sides. 4 plates for the
Rotary 200.
C) Mount the handles X and Y on their drive axes.
D) Screw the measuring rule cables to the housing, connect the
housing to the computer. Connect the 110/220V plug to the
main electrical outlet and turn on the switch if present.
E) Attach the micrometric screws X and Y in their housings to a
maximum of 1.5N.
15