marcel aubert Rotatif 50 Mode D'emploi page 19

 Measurement: Vertical optics 3), To move your part, use the handwheels 7) and 19). If neces-
sary, you can disengage them using levers 8) and 18). Horizontal optics 27) ; Use the crank
10) in column 11) and the cranks 7) and 19) for positioning and sharpness.
 Tool holder in "V" 12) : Use the crank of this bracket to orient your object at an angle suitable
for the desired measurement. Please refer to the
formation.
 Lighting 6) and 9) : Adjust the light intensities using the lighting box 26). For ring lights 6),
switch on all sectors when you are in the measurement phase because it is important to have
as few shadows as possible for a reliable measurement. When you are looking to position your
object 33) on a specific edge, it is recommended to use the different combinations of illumina-
tions offered by ring lights 6). It should be noted that diascopic lighting 9) never in principle dis-
turbs episcopic lighting 6). The diascopic lighting 9) is particularly interesting for measuring the
profile of your room 33) using the vertical optics 5). If you lack light intensity on your episcopic
lights 6), you can remove the opal filters 28). For more information, refer to operating instruc-
tions MA 356-042-02.
 Horizontal optical rotation 27): This lens 27) allows you to observe and measure your object
at the end but also from other angles as shown below. Always use lever 30) and do not use the
camera or optics 27) to change your angle of vision as this may disturb them. First unlock
screw 4). Index 29) shows you the angle at which you are standing. The notches 32), which
are indexed on the positioning fingers 31), can be adjusted according to the specific angles of
the objects to be inspected 33).
+135°
Troubleshooting
Descriptions :
The lighting box 26) or the lighting 6) or
9) are defective.
Camera 2) malfunctions or does not
work.
A "License Error" or "Li-cense Not
rotatif$24.docx
"Concentricity
+90°
Procedures :
1. Check that the cables are correctly inserted in
the plugs.
2. If this is not enough, refer to the operating in-
structions MA 356-04-02.
3. If you need to order a replacement power
supply, take the order number if killed under
the housing.
1. Check that the camera indicator light is
green. If this is not the case, it means that the
camera is not powered.
Pro" user manual for more in-
-45°
19