General - Titan B 50 BR Notice D'instructions

2.

General

Many thanks for your confidence in the technology of
These operating instructions are intended to simplify familiarisation with the steel strap cutter
B 50 BR and the possibilities of application for the intended purpose. The operating
instructions contain important information concerning the safe, proper and efficient
use of the strapping tool. Following the instructions helps avoid risks, reduces repairs and
downtimes and increases reliability and life of the cutter.
The operating instructions must always be available at the place of operation of the cutter.
They must be read and observed by persons concerned with work on the cutter. This work
specifically includes operation, refilling of operating material, fault elimination and
maintenance.
Apart from the operating instructions and the regulations for the prevention of accidents
being applicable in the country where the unit is operated and on site the recognized
technical rules for safety-related and competent works have to be observed.
Explanatory notes on the warning and instruction symbols:
Caution!
Used to indicate danger to life and limb.
Attention!
Used to indicate danger that can result in material damage.
Notice!
Used to indicate general information and information which if ignored can
cause disruptions in operation
The manufacturer reserves the right to make changes to the scope of delivery
at any time for the purpose of improving the product.
Copyright © TITAN Umreifungstechnik GmbH & Co.KG 2012 all rights reserved.
The contents of this document must not be duplicated, handed to third parties, published or saved in any form,
neither fully nor partly, without prior written permission by TITAN Umreifungstechnik GmbH & Co.KG.
B 50 BR
TITAN Umreifungstechnik GmbH & Co. KG
is a registered trademark of TITAN Umreifungstechnik GmbH & Co.KG.
H 761 EU 11/12
.
11 / 28