Detergent Tank Cleaning - Clarke FOCUS II Manuel D'utilisation

ENGLISH

DETERGENT TANK CLEANING

(For machines with Chemical Mixing System)
Clean the detergent tank (C, Fig. 35) as shown below:
1. Drive the machine to the appointed disposal area.
2. Turn the ignition key (A, Fig. 34) to "0".
3. Open the cover (B) and check that the recovery water tank
(C) is empty; if necessary empty it with the drain hose (D).
Close the cover (B).
4. Carefully lift the tank (C).
5. Unscrew the plug (A, Fig. 35) and disconnect the hose (B)
from the tank (C).
6. Remove the tank.
7. Wash the tank in the appointed disposal area.
8. Install the tank (C) and connect the hose (B).
9. After draining the detergent tank, drain the Chemical Mixing
System too by running the system with clean water only.
28
Operator's Manual - FOCUS
Figure 34
Figure 35
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
®