Squeegee Cleaning - Clarke FOCUS II Manuel D'utilisation

ENGLISH

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and its blades must be in
good conditions in order to get a good drying.
CAUTION!
It is advisable to wear protective gloves when
cleaning the squeegee because there may be sharp
debris.
1. Drive the machine on a level floor.
2. Turn the ignition key (A, Fig. 25) to "0".
3. Lower the squeegee (B) with the lever (C).
4. Loosen the knobs (D) and remove the squeegee (B).
5. Disconnect the vacuum hose (E) from the squeegee.
6. Clean the steel or the aluminum squeegee (Fig. 26). Clean
the compartments (A) and the hole (B) especially. Check the
front blade (C) and the rear blade (D) for integrity, cuts and
tears; if necessary replace them (see the procedure in the
following paragraph).
7. Assemble the squeegee in the reverse order of disassembly.
24
Operator's Manual - FOCUS
Figure 25
Figure 26
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
®