Clarke FOCUS II Manuel D'utilisation page 15

Cylindrical brush installation/removal (only for FOCUS
II L20 Cyl.)
1. Turn the ignition key (A, Fig. 11) to "0".
2. Lift the cylindrical brush deck by pressing the pedal (B).
3. Turn the knobs (A, Fig. 12) and remove the doors (B) by
pushing them downwards and pressing on the knobs.
4. Install the cylindrical brushes (C).
The cylindrical brushes can be installed on either sides.
5. Install the doors (B) and fasten them with the knobs (A).
6. To remove the cylindrical brushes, perform steps 1 to 5 in the
reverse order.
Operator's Manual - FOCUS
Figure 12
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
Figure 11
L20
®
ENGLISH
15