Sony CBK-3610XS Mode D'emploi page 19

Note
Orient the lens side face down when placing the
removed imager block on a flat surface. If the heat
sink side is placed face down, the flangeback
(flange focal distance) may be adversely affected.
2
Attach the imager block, removed in
step 1, to the imager block adapter.
Align and attach using the four supplied hex
screws, and tighten using a hex wrench
(tightening torque of 1.4 N·m).
3
Attach the camera body adapter (
and then attach the bottom plate (
Align and attach using the eight hex screws,
removed in step 1, and tighten using a hex
wrench (tightening torque of 1.4 N·m).
1
2
Short
4
Attach the imager block adapter
)
1
receiver to the camera body adapter.
).
2
Align with the index marks on the top and
sides of the receiver, and attach using the two
hex screws, and tighten using a hex wrench
(tightening torque of 1.4 N·m).
Index mark
Index
mark
Attaching to the Camera
19