Maintenance; Troubleshooting - Num'axes CANICOM 200 First Guide D'utilisation

- Never leave a discharged battery in the unit: leakage could damage your CANICOM 200 FIRST.
- Remove the battery from the receiver collar and the remote control if you are not using the appliance
for 3 months or more. The collar will memorize the configuration chosen (coding).
- Keep your CANICOM 200 FIRST unit out of reach of children. It is not a toy for you or your children.

Maintenance

- Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and
neutral detergent.
- In order to maintain water tightness, we recommend the replacement of the seal located in the receiver
collar every year.

Troubleshooting

Should your CANICOM 200 FIRST stop working or develop a fault, first read this user's guide over, then
check the batteries (see § Checking/replacing battery of remote control and § Checking replacing battery
of receiver collar) and replace them if necessary and retry. Also check that you are using the product
correctly.
If you encounter any problems, re-code the receiver collar (ref. re-coding procedure).
Re-initialize the system by removing the battery from its housing, then with a metallic tool (e.g.
screwdriver, scissors) touch each of the 2 battery contacts for 2 seconds approximately (ref. Diagram 6).
Insert the battery again: One beep is emitted, indicating the battery is in correct position.
Gb - 29
Diagram 6
Reset: connect
the 2 supports of
the battery