SFA SANICOM 1 Notice D'installation page 23

EN
• Every 6 months for lifting stations installed in collective buildings
• Once a year for lifting stations installed in individual houses
During maintenance, the following should be done:
a) Check the watertightness of connections by checking pipework to
and from the lifting station
b) Activate the gate valves, check their smooth function and their
watertightness ( grease if necessary)
c) Open and clean up the non return-valve system, check it is func-
tioning correctly
d) Clean up the pumping system and its connections, check the im-
peller and the cutting system (for macerating pumps)
e) Clean up the inside of the collecting tank
f) Visually check the lifting station's electrical control box functions.
Once the checks have been made, restart the lifting station in com-
pliance with the manual instructions to check its proper running.
A report should be issued detailing the checks and any notable
points.
If non-compliances that cannot be solved have been found, the qual-
ified person in charge of the maintenance work has to immediately
inform the lifting station's user.
8.3 MAINTENANCE CONTRACT
It is advised to the users to establish a maintenance contract for
regular maintenance and checking.
9. FAULT FINDING GUIDE
9.1 ALARM ON SANICOM 1 DEVICE
FAULT DETECTED POSSIBLE CAUSES
Flashing red alarm LED • Water level detection
system faulty
Steady red alarm LED • Blocked vent pipe
• Blocked discharge
• Blocked pump or out
of order
• Discharge too high or
excessive inflow
LED off • Power outage
• Faulty printed circuit
board
9.2 ALARM ON THE SANICOM 2 CONTROL BOX
FAULT DETECTED POSSIBLE CAUSES
Siren + flashing red • Water level detection
general alarm LED system faulty
Siren + steady red • Blocked vent pipe
general alarm LED
• The device has
encountered the following
problem: blocked pipe,
pump(s) blocked
• The device has
encountered a power
failure
Siren + general alarm • Mains cut
LED + flashing yellow
mains LED
10. DISMANTLING
INSTRUCTIONS RESERVED EXCLUSIVELY
FOR QUALIFIED PROFESSIONAL
SPECIALISTS
If one of the motors cannot be made to operate cor-
rectly, use of that motor can be "disabled" by set-
ting the corresponding switch on the board (P1, P2 :
Switches 1 and 2 for motors 1 and 2).
The motor thus "disabled" can be removed. The unit
operates on the other motor.
11. COMPLIANCE WITH STANDARDS
This device complies with EN 12050-2 (Wastewater lifting plants for
faecal-free wastewater) of the Construction Products Regulation
and with the European Low Voltage, Electromagnetic Compatibility
and Machine Directives.
12. GUARANTEE
2 years guarantee as from its date of purchase subject to correct
installation and correct use.
unit, and will invalidate the guarantee.
ACTION TO BE TAKEN
• Consult SFA after-sales
service
• Check that air flows freely
in both directions in the vent
pipe
• Review installation
• Consult the SFA customer
services
• Check the electrical system
• Consult the SFA customer
services
ACTION TO BE TAKEN
• Consult the SFA customer
services
• Check that air flows freely
in both directions in the vent
pipe
• Press the manual start
button to reset the device
(alarm off)
• Consult SFA customer
services
• To stop the siren, press on
the Force Start button
• Check the electrical system
• Consult the SFA customer
services
14
Any damage due to foreign bodies such as cotton, con-
doms, sanitary towels, wet wipes, food, hair, metal, wood
or plastic objects, will not be under guarantee. Solvents,
acids and other chemicals can also cause damage to the