Turning On/Off; Delayed Stop" Function; How To Care For The Hood; Cleaning The Grease Filters - SCHOLTES SOTH1900B Manuel D'utilisation

3.2 Turning on/off

Press the on/off button "T1" for a second and the hood will turn on at speed
1.
To increase the speed (2, 3, 4/intense), press the "+" button (T3).
To reduce the speed, press the "-" button (T2) (4/intense, 3, 2, 1).
Note: The "Booster" function (intense) lasts for 5 minutes before automatically going back down to speed 3. The display will
show a flashing "4" for 5 minutes. It will then show the number "3" without flashing when it goes back down to speed 3.
To turn the hood off, press the on/off button "T1 ".
It will be turned off no matter which speed it was on.
Note: To clean the hob without turning the hood on, press the "-" button (T2 ) for 5 seconds.
This will lock the control panel for one minute so you can clean the surface.
The display will show "C" throughout this minute. After this, the hood will start working as normal.

3.3 "Delayed stop" function

This function lets the hood turn off automatically after a set time.
Choose the hood speed you want. Press the button "T4 ". The display "D " will show a flashing " 1 " and a decimal point. The
decimal point shows that the "Delayed stop" function has been activated.
Use the "-" (T2 ) and "+" (T3), buttons to choose the delay as follows:
1= 5 minutes
2= 10 minutes
3= 15 minutes
4= 20 minutes
Press the button "T4 " to confirm your choice.
Note: You can change the hood speed using the "-" (T2) and "+" (T3) buttons. You can turn the hood off manually using the
on/off button (T1).
You can also change the set delay by pressing the button (T4 ) again and setting the new delay. It will start counting from 0
again.
When the "Delayed stop" function is active, the display will alternately show the chosen hood speed for 5 seconds followed by
the delay for 5 seconds. The delay will flash.

4. HOW TO CARE FOR THE HOOD

4.1 Cleaning the grease filters

The grease filters must be cleaned when the display shows the letter " G " (after 30 hours of use). To reset the display, press the
"+" button (T3) for 5 seconds with the hob off.

4.2 Replacing the carbon filter

The carbon filters must be replaced when the display shows the letter "S" (after 120 hours of use).
To reset the display, press the "+" button (T3 ) for 5 seconds with the hob off.
Note: The message will appear even if the vent is not being used on "recycle" mode. If this happens, clean the filters as normal and
reset the display.
31