TERMA MEG Mode D'emploi page 22

In order to modify the temperature span, unplug the de-
vice and plug it back in, while pressing
diode will start winking on the display panel. Use
buttons to set one of the 5 possible maximum tem-
peratures. The first diode stands for 45° C. The following
diodes refer to the following maximum temperatures:
50° C, 55° C, 60° C and 65° C.
The device will go back to its previous setting after press-
ing button.
22
User manual Meg, Moa, Reg 2, Reg 3 www.termagroup.pl
Problem solving
Problem
The device
is plugged
in, no diodes
are on.
button. A single
and Heating
element is not
heating, out-
side diodes
are winking
alternately.
The device is
heating de-
spite turning
it off with the
button.
If the problem continues please contact Your local
Distributor.
Possible
Solution
cause
Check the connec-
Problem with
tion of the power
the connec-
wire, the plug and
tion.
the socket.
Disconnect the
Temperature device completely,
sensor has wait until the
been dam- radiator cools down
aged. and connect it back
again.
Check if the radiator
has been filled
with the heating
Overheating
agent in a proper
of device.
manner according
to manufacturer's
instructions.
Disconnect the
device completely,
Electronics wait until the
damage. radiator cools down
and connect it back
again.