TERMA MEG Mode D'emploi page 21

MOA
Turning on the device with the
heating of the radiator up to the set temperature. After
reaching the set temperature the device will turn off and
back on regularly in order to keep the set temperature.
Construction of the device as well as the physical
characteristics of the heating agent inside the radiator
influence the way in which the heat is distributed — the
temperature of the bottom pipes of the radiator (espe-
cially the two located at the very bottom of the radiator)
may be lower than the temperature of the remaining
parts of the radiator — this is a normal phenomena.
Temperature increase
In order to increase the temperature of the radiator,
press once or several times as required; the right
number of diodes will start winking. The last winking
diode indicates the set temperature whilst the last diode
which is shining with the constant light indicates the cur-
rent temperature. The following diodes will start shining
constantly on reaching subsequent temperature levels.
Temperature decrease
In order to decrease the temperature of the radiator,
press once or several times as required; the right
number of diodes will start winking. The last diode that
is shining constantly indicates the set temperature
whilst the last winking diode indicates the current
temperature. The following diodes will start fading on
reaching subsequent temperature levels.
Anti-freeze function
When the device is off and the temperature around tem-
perature sensor drops down below 6° C, the device will
turn on/off button,
temperature regulation
dryer function
button results in
en
switch on automatically. This is to prevent the heating
agent inside the radiator from freezing. Activating
Anti-freeze mode is indicated by winking of the middle
diode.
Dryer function
The Dryer turns the device on for 2 hours, ie. in order
to dry a towel. After this period of time the device
automatically switches to the mode from before the
dryer mode.
The dryer is turned on by pressing button
the device is off). The device will start working with the
temperature that was last set up. This temperature can
be modified as required during the device is working
(buttons and ). If the device was off before the dryer
mode has been activated, then it will turn off automati-
cally after the dryer mode is finished.
Press button at any time to interrupt the dryer mode.
Calibration of the temperature span
Standard temperature span of the heating element is
30-60° C. It is possible to increase or decrease that span
by setting maximum temperature between 45° C and
65° C (minimum temperature of 30° C stays unchanged).
This allows to achieve a maximum temperature higher
than the standard or to navigate the device within the
lower temperatures.
Example: for the temperature regulation span up to 45° C
(30-45° C) modification by one step (one diode), means
increase/decrease of temperature by 3.75° C, whereas
for the temperature regulation span up to 65° C
(30-65° C) modification by one step means increase/
decrease by 8.75° C.
(also when
21