TERMA MEG Mode D'emploi page 20

MEG
Turning on the device results in heating of the radiator
up to the set temperature. After reaching the set tem-
perature the device will turn off and back on regularly in
order to maintain the set temperature.
Construction of the device as well as the physical
characteristics of the heating agent inside the radiator
influence the way in which the heat is distributed — the
temperature of the bottom pipes of the radiator (espe-
cially the two located at the very bottom of the radiator)
may be lower than the temperature of the remaining
parts of the radiator — this is a normal phenomena.
Temperature increase
In order to increase the temperature of the radiator,
press once or several times as required; the right
number of diodes will start winking. The last winking
diode indicates the set temperature whilst the last diode
which is shining with constant light indicates the current
temperature. The following diodes will start shining
constantly on reaching subsequent temperature levels.
Temperature decrease
In order to decrease the temperature of the radiator,
press once or several times as required; the right
number of diodes will start winking. The last diode that
is shining constantly indicates the set temperature
whilst the last winking diode indicates the current
temperature. The following diodes will start fading on
reaching subsequent temperature levels.
Anti-freeze function (anti-freeze protection)
When the device is off and the temperature around tem-
perature sensor drops down below 6° C, the device will
switch on automatically. This is to prevent the heating
20
User manual Meg, Moa, Reg 2, Reg 3 www.termagroup.pl
turn on / off button
temperature regulation
agent inside the radiator from freezing. Activating
Anti-freeze mode is indicated by winking of the middle
diode.
Problem solving
Problem
The device
Problem with
is plugged
the connec-
in, no diodes
tion.
are on.
Temperature
sensor has
been dam-
aged.
Heating
element is not
heating, out-
side diodes
are winking
alternately.
Overheating
of device.
Heating ele-
ment is heat-
ing despite Electronics
turning it off damage.
with the on/
off button.
If the problem continues please contact Your local
Distributor.
Possible
Solution
cause
Check the connec-
tion of the power
wire, the plug and
the socket.
Disconnect the
device completely,
wait until the
radiator cools down
and connect it back
again.
Check if the radiator
has been filled
with the heating
agent in a proper
manner according
to manufacturer's
instructions.
Disconnect the
device completely,
wait until the
radiator cools down
and connect it back
again.