Güde PROFI 36618 Mode D'emploi Original page 11

Every three months or when the impact wrench is in
operation only occasionally you must remove the air hose
and add more pneumatic oil to the air inlet. Then, refit the air
hose and let the impact wrench run for app. 30 seconds to
allow the compressor engine to clean out. After cleaning,
follow the lubrication instructions.
Troubleshooting
Problem Possible cause
No power Too small amount of air
(see Technical
specifications)
Impact Insufficient air pressure
wrench not
working or
working too
Air pressure set too low
slow
Impact wrench must be
lubricated with oil
Impact wrench must be
cleaned out
Air hose is leaking
Problem solution
Bigger compressor
Check the air pressure
on the air inlet. It must
be 6 bar.
Increase the pressure
to 6 bar
See Lubrication
See Servicing
Tighten all the hose
screwing
11
EU DECLARATION OF CONFORMITY
We,
Güde GmbH & Co. KG
Birkichstrasse 6
74549 Wolpertshausen
Germany
hereby declare that the design of the appliances below
corresponds to the applicable requirements of the basic EU
safety and hygiene directives.
In case of alternation of the appliance, not agreed
upon by us, this Declaration will lose its validity.
Appliance marking / Art. No.
½" PROFI / #36616 Pneumatic Impact Wrench
½" PROFI TWIN / 36618 Pneumatic Impact Wrench
Applicable EU Directives:
2006/42/EG
Applicable harmonised standards:
EN
EN
Date/authorised signature:
Title of signatory:
Technical documentation:
Managing Director,
Mr Arnold
J. Bürkle FBL; QS