Pando E-320 Instructions D'utilisation page 25

Other functions:
Automatic turn off:
After 4 hours of continuous working from the last
setup, the appliance turns off and closes automa-
tically.
Grease filters saturation:
After 30 hours of working, the speed indicators
"D" will all flash simultaneously, signaling the gre-
ase filters saturation.
To reset this alarm, hold down the "TIMER" button
for at least 3 seconds, while the carriage is open.
Downdraft calibration:
Downdraft calibration After having installed the
Downdraft, it is necessary to start the calibration
procedure, which is aimed at adjusting the extrac-
tion strength of the filtering unit.
Connect the product to the power line, making
sure that it is conformed to the supply voltage
indicated on the technical data tag.
Pushing the (fig. 15B / fig. 16H) button the aspira-
tion panel rises.
After it has reached a height of 180 mm from the
cooketop, press (fig. 15B / fig. 16G), to stop the
extraction then the Timer and after 2 sec. the (fig.
15B / fig. 16G) button.
The downdraft will carry out the calibration of its
aspiration panel rising and retracting for some
centimeters. During this phase, the buttons on the
pushbutton control panel blink.
At the end of the calibration, the aspiration panel
get back to the previous position and the button
end to blink. Wait until the aspiration panel stops
moving before re-activating the extraction.
E-320
EN
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the
European Commission, which came into force as
from January 1st, 2015 , our products have been
adapted to comply with these new requirements.
All of the models complying with the energy la-
bel requirements, are equipped with new
electronics including a timer device for suction
speeds control, when the air capacity exceeds
650m³/h.
Internal motor models, with maximum air capacity
higher than 650m³/h, are equipped with a timer de-
vice that automatically switches the suction speed
from 4th to 3rd speed, after 6 minutes operation.
External motor models are equipped with remote
motors that , as for internal motor versions, inclu-
de a timer device that switches down the suction
speed when it exceeds 650 mᵌ/h. (See External
Motors Instructions).
Remote motors, whose air capacity exceeds
650m³/h at both 4th and 3rd speed , will have the
following by default timer control functions:
The suction speed is automatically switched from
4th to 2nd speed, after 6 minutes operation.
If the appliance is working at 3rd speed, it is auto-
matically switched to 2nd speed, after 7 minutes
operation. Operation speeds can also be changed
during operation.
The energy consumption of the appliance in stand
– by mode is lower than 0.5W.
Security system:
If there is an obstacle while the extractable unit
is closing, the Downdraft stops closing and rises
again thanks to a security system.
WARNING
This operation has to be carried out by a
specialized technician.
25