Sony CMT-X3CD Mode D'emploi page 25

Play does not start.

Turn off the system and reconnect the USB
device, then turn on the system.

An incompatible USB device may be
connected.
Play does not start from the first track.

Make sure the current play mode is correct. If
the play mode is "SHUFFLE" or "PROGRAM,"
change the setting (page 9).
The USB device cannot be charged.

Make sure the USB device is connected
(USB) port .
securely to the

The USB device may not be supported by this
system.

Disconnect the USB device and then reconnect
it. For details on the charging status of the
USB device, see the operating manual of the
USB device.
Tuner
Severe hum or noise occurs ("STEREO"
flashes in the display window ), or
broadcasts cannot be received.

Connect the antenna properly.

Find a location and an orientation that provide
good reception, and then set up the antenna
again.

Keep the antennas away from the unit or
other AV components to avoid picking up
noise.

Turn off nearby electrical equipment.
Several radio stations can be heard at the
same time.

Find a location and an orientation that provide
good reception, and then set up the antenna
again.

Bundle the antenna cables using
commercially available cord clips and adjust
the cable lengths.
To reset the system to factory
settings
If the system still does not operate properly,
reset the system to factory settings.
1
Turn on the system.
Press and hold FUNCTION  and   on
2
the unit at the same time until "RESET"
appears on the display window .
All user-configured settings, such as preset
radio stations, timer, and the clock, are deleted.
If the problem persists after doing all of the
above, consult your nearest Sony dealer.
Note
 If you dispose of the unit or give it to another
person, reset the unit for security.
25 GB