Sony CMT-X3CD Mode D'emploi page 22

3 Press /  to select "PLAY
SET," then press
The start time flashes in the display
window .
4 Press /  to select time, then
press
Follow the same procedure to set
"MINUTE" of the time to start operation,
then "HOUR" and "MINUTE" of the time
to stop the operation.
5 Press /  to select the
desired sound source, then press
.
The confirmation display for the Play
Timer appears.
6 Press /  to turn off the
system.
Tip
 When the sound source is a radio, make sure to
tune-in to the radio station before turning off
the system (page 12).
 To change the timer setting, perform the
procedures from the beginning again.
Note
 The system turns on exactly at the time set in
Play Timer. When the sound source is a CD,
MP3/WMA disc or USB, it may take some time to
start playback.
 The Play Timer does not work if the system is
already on at the preset time.
 When the sound source for a Play Timer is set to
a radio station, the last played frequency is used
for a Play Timer. If you change the radio
frequency after setting the timer, the radio
station setting for the timer will also be
changed.
To check the setting
1 Press TIMER MENU .
Press /  to select "SELECT," then
2
.
press
3 Press /  to select "PLAY SEL," then
.
press
22
GB
.
.
The timer setting appears in the display window
.
To cancel the timer
Select "OFF" in step 3 of "To check the
setting" (page 22).