Preparing For First Use; Mount The Coil Spring; Insert / Replace The Soldering Tip; First Use - Parkside PLS 48 D2 Mode D'emploi

Preparing for first use

Mount the coil spring

Insert the clip of the coil spring
„
of the soldering station that is provided for this purpose (see foldout
page).

Insert / replace the soldering tip

CAUTION! RISK OF BURNS!
Never heat the soldering iron
f
The soldering tip may only be removed with the device switched off
„
and with the soldering tip cooled down.
The soldering tip has a screw thread and can therefore be replaced
„
quickly and easily on the soldering iron.
To remove, turn the soldering tip anti-clockwise.

To secure, turn the soldering tip clockwise.


First use

Switching on / off and setting the temperature

Switch on and set the temperature
Connect the plug into a suitable mains socket and press the ON / OFF

switch into the position "I". Turn the temperature regulator
the desired temperature.
NOTE
Before use, remove the protective cap from the soldering tip
f
.

PLS 48 D2
as far as it will go into the recess


without soldering tips

.

and set
GB | IE |
25