Graef ES 90 Notice D'utilisation page 54

Espresso Machine ES 90 / ES 91
Programming
Espresso"
EN
Put the single-ply filter in-
‹
sert for 2 cups into the group
handle and fill it with coffee
grounds.
Press down the coffee grounds
‹
firmly and insert the group
handle.
Put a cup underneath the
‹
group handle.
Press the "PROGRAM" button.
‹
Then press the "
‹
Press the button again when
‹
you have the desired amount
of espresso.
2 beeps inform you that the
‹
new setting for "double es-
presso" is programmed and
saved.
Factory settings
To revert back to the factory
settings, make sure the unit is
switched off and proceed as fol-
lows:
Keep the "MANUAL" button
‹
pressed and press the "POW-
ER" button at the same time.
Release the "MANUAL" but-
‹
ton.
When you hear 4 acoustic sig-
‹
nals and the "POWER" button
is illuminated the factory set-
tings are restored.
54
"Double
" button.
Single espresso 30 ml
Double espresso: 60 ml
Other programming
facilities
Espresso thermoblock
temperature
The water temperature of this
unit is set to approx. 92°C on the
brewing head. The temperature
of the water can be changed by a
maximum of +/- 4°C in 2°C steps.
To do so, proceed as follows:
Plug the plug into the electric
socket.
Please note: Even though the
unit is connected to the mains,
the unit must be switched "off".
That is why no control lamps on
the unit are lit.
Press the " " button and keep
it pressed.
While pressing the "
ton, press the "POWER" button
and then release the "POWER"
button.
That enables unit programming.
Now let go of the "
Within 5 seconds, pres one of the
buttons listed to raise or lower
the temperature:
" but-
" button.