M.retractable Joystick Mount; N.midline Joystick Mount; O.seat Depth Adjustment - Quickie QM-710 Mode D'emploi

Q M- 7 10/7 15HD/ 72 0
M. RETRACTABLE JOYSTICK MOUNT
The Retractable Joystick Mount can swing in/out in increments of 45°, 90°, and 135°
1. Height adjustment
a. Remove the Joystick mount (A) by removing hardware (B).
b. Flip bracket (C) upside down and re-attach the Joystick mount assembly components
c. Replace and retighten bolts on each side.
N. MIDLINE JOYSTICK MOUNT
The Midline Joystick Mount has 3 axis adjustment, and can be rotated out of the way.
1. Left, Right, Center adjustment
a. Loosen the clamp screws (D) and move the joystick laterally in front of the rider.
b. After finding the most comfortable adjustment, make sure the Joystick is level.
c. Retighten the clamp screws.
2. Height adjustment
a. Loosen the clamp screw (E) and move the joystick vertically,
b. After finding the most comfortable adjustment, retighten the clamp screw.
O. SEAT DEPTH ADJUSTMENT
The seat depth can be adjusted in one inch increments on standard Rehab Seating.
1. Seat Frame Depth Adjustment
a. To adjust, remove the two bolts (F & G) from each side of the backrest pivot plate.
b. Reposition the backrest to the desired position.
c. Replace and retighten bolts on each side of the backrest pivot plate.
2. Back Angle Adustment on Seat Frame
a. Remove the front securing bolt (F) on the side of the backrest hinge plate.
b. Loosen the lower rear bolt (G)
c. Set at desired angle. There are five holes (in 4º increments) to choose from.
d. Reinstall the front bolt and tighten both bolts securely.
Seat adjustment ASAP Seating.
1. Seat Frame Depth Adjustment
a. To adjust, loosen, or remove, the two bolts (J).
b. Reposition the backrest to the desired position.
c. Tighten bolts securely.
2. Back Angle Adjustment on Seat Frame
a. Remove the securing bolt (H) on the backrest plate.
b. Loosen the upper bolt (I)
c. Set at desired angle. There are five holes (in 12º increments) to choose from.
d. Reinstall bolt (H) through the back post and back plate, and then into the
mounting hole on the armrest. Tighten both bolts securely.
58
59
10" - 18", 12" - 20" only
61
XI. DEALER SERVICE AND ADJUSTMENT
60
29
58
59
60
61
MK-100158 Rev. F