Q M- 7 10/7 15HD/ 72 0
If you use parts or make changes not authorized by Sunrise it may
create a safety hazard and will void the Warranty.
A. ARMRESTS
1. Armrests will not bear the weight of this chair.
2. Never lift this chair by its armrests. They may come loose
or break.
B. BATTERIES
1. For safety reasons: Only use sealed non-spillable batteries
that meet DOT CFR 173.159 (d), IATA Packing Instructions
806, and IATA Provision A67 shall be installed in this wheel-
chair.
5. Read all of section X. Batteries before attempting to change,
or charge your batteries.
C. CUSHIONS & SLING SEATS
1. Standard foam cushions and other body supports are not
designed for the relief of pressure. Do not sit directly on a
sling surface.
2. If you suffer from pressure sores, or if you are at risk that
they will occur, you may need a special seat system or a
device to control your posture.
• Consult your Healthcare Professional to find out if you
need such a device for your well-being.
D. FASTENERS
Many of the screws, bolts and nuts on this chair are special high-
strength fasteners. Use of improper fasteners may cause your
chair to fail.
1. Only use fasteners provided by Sunrise.
2. If fasteners become loose, tighten them immediately.
3. Over- or under-tightened fasteners can cause damage to
your chair or it's components.
E. FOOTPLATE & FOOTRESTS
1. At the lowest point, footrests should be at least 2 1/2 inches
(65 mm) off the ground. If set too LOW, they may "hang
up" on obstacles you can expect to find in normal use. This
may cause the chair to stop suddenly and tip forward.
2. To avoid a trip or fall when you transfer:
• Make sure your feet do not "hang up" or get caught in the
space between the footrests.
• Avoid putting weight on the footrests, as the chair may tip
forward.
• Remove or swing the footrests out of the way, if possible.
3. The footrest should always be in the down position when
operating the chair.
4. Never lift this chair by the footrests. Footrests detach and
will not bear the weight of this chair. Lift this chair only by
non-detachable parts of the main frame.
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
VII. WARNINGS: COMPONENTS & OPTIONS
F. MOTOR LOCKS
1. Do not engage or disengage motor locks unless power to the
chair is off.
2. Be aware that the chair will not have brakes when motor
locks are in the free-wheel position.
3. Make sure that the person pushing the chair has full control
when motor locks are disengaged.
4. Make sure that the chair is on level ground when motor
locks are disengaged.
G. ON/OFF SWITCH
1. Never use the ON/OFF switch to stop the chair except in
an emergency. This will result in an abrupt stop, and may
cause you to fall.
2. To slow your chair to a stop, return the joystick to neutral.
H. PNEUMATIC TIRES
Proper inflation extends the life of your tires and makes your chair
easier to use.
1. Do not use this chair if any of the tires are under- or over-
inflated. Check weekly for proper inflation level, as listed on
the tire sidewall.
2. Low pressure in a tire may cause the chair to veer to one
side and result in a loss of control.
3. An over-inflated tire may burst.
4. Never use a gas station air pump to inflate a tire. Such
pumps provide air at high volume, and could cause the tire
to burst. To prevent tire damage:
• Use a hand pump (or low volume air pump) to inflate tires.
• Use a tire gauge to check pressure.
5. Driving over sharp objects may cause damage to pneumatic
tires and tubes.
I. MOTOR AND SUSPENSION SPRINGS
The motor springs and suspension springs are set to factory
defaults when the chair is manufactured. These springs should not
need to be adjusted and/or detached from the chair.
For the Safety of the user and stability of the chair:
1. Never use a spanner wrench to adjust the springs on this
chair.
2. Do Not remove the motor or suspension springs
3. If the springs need replacing, contact Sunrise Medical
Customer Service for parts and service information.
11
WARNING
WARNING
WARNING
WARNING
MK-100158 Rev. F